PCB Piezotronics Larson Davis BAS002, Manual

Page: 37 / 75

7-3 Configuring TCP/IP BAS002
FIGURE 7-2 BAS002 Software Connection
Upon being launched, the software searches for a client. In
this state the
Connect icon is red and flashing. If the LAN
AutoLink option is checked, the software searches for a
BAS002 unit on the same network subnet. The static IP
address of the BAS002 amplifier is always 192.168.1.2. The
IP address of the PC used to run the software must be in the
same subnet as the amplifier. Accordingly, it will be
192.168.1.x, where x is a number between 1 and 254,
excluding number 2.
The software controls are not enabled until the connection is
established with the amplifier. Upon connection, the connect
icon changes to green and the previously-specified settings
are loaded.
Configuring TCP/IP
If a message appears indicating limited or no connectiviy,
make sure that your PC is assigned a static IP address within
the same subnet. Also, if your router is set to configure TCP/
IP addresses automatically, through DHCP, the PC will not
find the amplifier.
This section shows how to configure TCP/IP on a Windows
7 operating system, as follows:
Step 1 To view the current network connection details,
click the Control Panel from the Start menu and then click
Network and Sharing Center .