Paul thermos 300 DC, Operating Instructions Manual

Page: 42 / 72

Status 14.07.09
We reserve the right to make
changes favouring technical
progress.
Technical Description
Automatic Control
thermos 200 / 300 DC
© Paul Wärmerückgewinnung GmbH • August-Horch-Straße 7 • 08141 Reinsdorf • Deutschland
Tel: +49(0)375-303505-0 • Fax: +49(0)375-303505-55 • E-Mail: info@paul-lueftung.de • Internet: www.paul-lueftung.de
6
4. Switch module 2.1 kW
The switch module is a universal module used to switch on an electric 230 VAC load with a maximum wattage of
2.1 kW.
The switch module is operated by the HCE via the 34-pos. bus connector.
The power pack supplies the module with 230 VAC via its voltage distribution terminals. When connecting the switch
modules to the voltage distribution of the power pack, take care to ensure the individual phases are loaded
symmetrically.
Use a 3-core cable for direct load connection to connector 2 of the power module (inverted 3-pole plug).
To select the function for the module, it is necessary to place two jumpers for the start-up – both jumpers must have the
same position in the male connectors.
Functions
1=Frost protection
2=Back-up heater (electric / hot water) or heating circuit
!!! IMPORTANT: Both jumpers must be in the same position on the module. !!!
The hardware detection and module function assignment will be automatic via the bus line.
One module can be assigned to one function only. Maximum eight different modules can be connected to the internal
bus.
Connections to the power module:
X_1 230 VAC - INPUT power supply, 3 pos., spring clamps
X_2 230 VAC – switch output (2.1kW) , 3 pos., inverted socket with plug
Phoenix IC 2,5/3-G-5,08 / 1786417