Paul thermos 300 DC, Operating Instructions Manual

Page: 29 / 72

Status 14.07.09
We reserve the right to make
changes favouring technical
progress.
User Guidance
Automatic Control Unit
thermos 200 / 300 DC
®
WÄRMERÜCKGEWINNUNG
© Paul Wärmerückgewinnung GmbH • August-Horch-Straße 7 • 08141 Reinsdorf • Deutschland
Tel: +49(0)375-303505-0 • Fax: +49(0)375-303505-55 • E-Mail: info@paul-lueftung.de • Internet: www.paul-lueftung.de
17
3.3 Service menu 2 Back-up duct heaters
-----------------------
|Service2 Backup DCTH |
|FHLK Off | TA1
|T0:22.0° x0:01.0° |
|H0:01.0° T5:30.0° |
|x5:50.0° H5:01.0° |
|STB4:+ FZ4:+ IFZ4:+ | TA2
| |
| -> |
-----------------------
TA5 TA4 TA3
This menu shows the parameters of the back-up duct heater.
FHLK capital letters mean:
small letters mean:
F duct heater enabled f duct heater not enabled
H hardware detected h hardware not detected
L ventilation enabled l ventilation not enabled
K cooling mode selected k cooling mode disabled
(heating is not possible)
T0 Room temperature
X0 Room temperature setpoint
H0 Hysteresis für x0 (x0 +/- H0)
T5 Duct temperature
X5 Max. duct temperature
H5 hysteresis for x5 (x5 +/- H5)
3.4 Service menu 3 Summer/winter bypass
-----------------------
|Service3 Bp_su_wi |
|FONKW | TA1
|T1:02.0° min:100 |
|T4:02.0° max:255 |
|x41:24.0° act:100 |
|x42:18.0 | TA2
|H4:01.0 |
| -> |
-----------------------
TA5 TA4 TA3
This menu shows the parameters for the summer/winter bypass.
FONKW
capital letters mean: small letters mean:
F bypass enabled f bypass not enabled
O bypass in proper position o bypass in wrong position
N back-up heater enabled n back-up heater disabled
K cooling mode enabled k cooling mode disabled
W heat pump ON w heat pump OFF
T1
Intake air temperature at the inlet of the unit
T4 Extract air temperature
min: Valve position CLOSED
max: Valve position OPEN
act: actual valve position
X41 selected temperature for bypass OPEN
X42 selected temperature for bypass CLOSED
H4 hysteresis for x41/x42 (x +/- H4)