WAN Service Configuration
56
Models 2603, 2621, and 2635 User Manual
6
• WAN Services
Click on the Create button.
4.
Go to
Services Configuration > WAN > Edit...
(for PPP routed)
> Edit ‘IP Interface’ > Ipaddr:
[enter the
WAN IP Address and Mask, in this example = 192.168.164.3 and 255.255.255.255].
5.
Click on
Create
.
6.
Go to
Configuration Menu > Configuration > IP Routes > Click on Create new Ip V4 Route
.
7.
Create the gateway to the remote OnSite by entering the WAN IP address of the remote OnSite, in this
example, enter 192.168.164.2 in the Gateway field
8.
Click
OK
.
The other fields should be:
•
Destination:0.0.0.0
•
Gateway:192.168.164.2
•
Mask:0.0.0.0
•
Cost 1
•
Interface: [blank]
You can see the status of the PPP link by going to the ‘Edit PPP’ web page and paging down until you see the
“Summary” description. To get to the ‘Edit PPP’ web page, follow this path:
Services Configuration > WAN >
Edit... > Edit ‘PPP’
LMI Management (Frame Relay links)
LMI Configuration
Frame Relay Local Management Interface.
The Frame Relay Local Management Interface (LMI) is a mecha-
nism that two separate frame relay systems can use to communicate the status of the interface. The LMI inter-
face allows dynamic updates on the status of the DLCI connections and the congestion state of the network.
The OnSite implements all three versions of LMI available within the frame relay network. These are defined
in table 3:
Table 3. LMI Implementation on the OnSite
Protocol
Specification
Options Available
LMI
Frame Relay Forum Implementation Agreement
(IA) FRF.1 superseded by FRF.1.1
User Side
Annex D
ANSI T1.617
User Side
Annex A
ITU Q.933 referenced in FRF.1.1
User Side
Note
LMI uses DLCI 0, but ANSI/CCITT has also reserved 1–15. Best practice
(per the recommendation) is to use only DLCIs 16–991 for FR data PVCs,
and DLCIs 0–15 for LMI PVCs.
