Network Address Translation (NAT) Setup
65
Model 3101 Series Getting Started Guide
5 • Advanced Configuration
Click the
Add
button to display the
Port Triggering Configuration
page.
Figure 69. WMI: Adding a Port Triggering Entry
•
Use interface:
Select an interface that you want to configure.
•
Select an application:
Select a proper application in the drop-down list.
•
Custom application:
Manually define an application.
•
Trigger port Start:
The start port number that LAN uses to trigger the open port.
•
Trigger port End:
The end port number that LAN uses to trigger the open port.
•
Trigger Protocol:
Select the application protocol. You may select TCP/UDP, TCP, or UDP.
•
Open Port Start:
The start port number that is opened to WAN.
•
Open Port End:
The end port number that is opened to WAN.
•
Open Protocol:
Select the proper protocol that is opened to WAN. You may select TCP/UDP, TCP, or
UDP.
Click
Save/Apply
to apply the settings.
Note
You can use a single port number, several port numbers separated by
commas, port blocks consisting of two port numbers separated by a
dash, or any combination of these (ex: 80, 90-140, 180).