WAN Service Setup
42
Model 3101 Series Getting Started Guide
5 • Advanced Configuration
3.
On the
PPP Username and Password
page, provide information for the PPP username, password, service
name, and authentication method.
Figure 24. WMI: PPP Information
–
PPP Username
: The valid username provided by your ISP.
–
PPP Password:
The valid password provided by your ISP.
–
PPPoE Service Name:
Enter the service name provided by your ISP. If the ISP does not provide a ser-
vice name, do not enter any information.
–
Authentication Method:
Select from AUTO, PAP, CHAP, MSCHAP. (Default = AUTO)
– Enable Fullcone NAT:
With NAT, all requests from the same internal IP address and port are mapped
to the same external IP address and port. Furthermore, any external host can send a packet to the inter-
nal host, by sending a packet to the mapped external address.
–
Dial on demand (with idle timeout timer):
If enabled, enter the
Idle Timeout
value in minutes. If the
3101 doesn’t detect the flow continuously within the allotted time, the unit will automatically discon-
nect the PPPoE connection. Once it detects the flow (such as access to a webpage), the 3101 will restart
the PPPoE connection. If disabled, the 3101 will perform PPPoE dial-up all the time. Unless the 3101 is
powered off and DSLAM or uplink equipment are operating abnormally, the PPPoA connnection will
stay up.
–
PPP IP Extension:
Enable this option if you want to configure a DMZ Host. If enabled, the WAN IP
address obtained by the 3101 through built-in dial-up can be directly assigned to the PC connected to
the 3101 (at this time, the 3101 has only one PC). If disabled, the 3101 obtains the WAN IP address.
–
Use Static IPv4 Address:
If enabled, the 3101 uses this IP as the WAN IP address. If disabled, the 3101
obtains an IP address assigned through uplink equipment.