Installing the gateway router
34
SmartNode 4520 & 4110 Series User Manual
3
• Hardware installation
Note
Unit must not connect directly to telecom network voltage (TNV).
Installing the Ethernet cable
The SmartNode 4520 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether-
net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable
(see
figure 20
on page 34). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode’s Ether-
net ports (see
table 7
for port pin-out listing) via a cable terminated with RJ-45 plugs. Because the SmartNode
4110 Series does not have the MDX feature, a cross-over cable is required when connecting SmartNode 4110
Series devices to a host (see
figure 21
on page 35).
Table 7. Ethernet 10/100Base-T (RJ-45) port pin-outs (SmartNode 4110 Series)
Pin
Signal
1
TX+
2
TX-
3
RX+
6
RX-
Note
Pins not listed are not used.
Figure 20. Connecting a SmartNode 4110 Series device to a hub
Summary of Contents for SmartNode 4520 Series
Page 47: ...47 Chapter 5 LEDs status and monitoring Chapter contents Status LEDs 48...
Page 74: ...74 Appendix E SmartNode 4110 Series factory configuration Chapter contents Introduction 75...
Page 76: ...76 Appendix F SmartNode 4520 Series factory configuration Chapter contents Introduction 77...
Page 78: ...78 Appendix G Installation checklist Chapter contents Introduction 79...
