Installing the gateway router
32
SmartNode 4520 & 4110 Series User Manual
3
• Hardware installation
Installing an interface cable on the router’s FXS and FXO interface ports
The gateway comes with at least two FXS or FXO analog ports—or a combination of FXS and FXO ports—(see
figure 16
) located on the back of the router. The FXS interfaces are connected to analog devices via cables (see
figure 17
) terminated with RJ-11 connectors (see
figure 19
and
table 6
on page 33 for pin-out information). The
FXO interface connects the router with analog lines via cables (see
figure 18
on page 33) terminated with RJ-11
connectors (see
figure 19
and
table 6
on page 33 for pin-out information).
Figure 16. Rear view showing location of Ethernet and FXS connectors (SmartNode 4520 shown)
Figure 17. Analog FXS connection
Summary of Contents for SmartNode 4520 Series
Page 47: ...47 Chapter 5 LEDs status and monitoring Chapter contents Status LEDs 48...
Page 74: ...74 Appendix E SmartNode 4110 Series factory configuration Chapter contents Introduction 75...
Page 76: ...76 Appendix F SmartNode 4520 Series factory configuration Chapter contents Introduction 77...
Page 78: ...78 Appendix G Installation checklist Chapter contents Introduction 79...
