Passap ELECTRONIC 8000, Operating Manual

Page: 45 / 266

Kn itting instructions
The meaning of the knitti ng instructions
When you start a new piece of knitting and when you change
from one pattern sector to another during knitting, knitting
instructions will appear on the display which have to be
followed in order to obtain the desired pattern. In addition,
there are techniques for which further instructions are
displayed during knitting, e
. g. information on the number of
turns of the handle for racking patterns.
Follow these instructions and continue knitting by pressing
GO.
If all necessary instructions cannot fit in the display, you will
see the "plus" sign in the bottom right corner. In this case,
before continuing knitting, please press ENT to be able to see
the remaining instructions.
Whenever knitting instructions appear, you can press
ENT to see the row counter information before continuing
knitting.
The following lists the meaning of all knitting instructions contained:
v
"
KX
LX
ox
ux
sx
HANDLE UP
HANDLE DOWN
v always means that everything which follows
refers to the front cam box
" always means that everything which follows
refers to the back cam box
These displays can appear in the first line and
designate the position of the pattern selector
dial and of the N-X lever. Please refer to
page 1 1 .
( Remember that the pattern selector dial can
only be turned when the N-X lever is in the N­
position. For knitting, however, it must be
in the X-position).
This display describes the position of the
racking handle, either up or down.
For up the end needles of both needle beds
have to be exactly opposite each other.
For
down
the first and last needles of the
front bed have to be slightly to the left of the
first and last needles of the back bed.
43