TurbiTechw² LR Instruction Manual
3 Safety Precautions
3.1 General
Read the safety precautions carefully.
Check the delivery of your WaterWatch² sensor for damage. Any damage should be reported to your supplier
as soon as possible.
Use care when unpacking the sensor.
NEVER
use sharp instruments to open the packaging, as this can
cause damage to the sensor or cable.
Only use accessories specifically manufactured by Partech for use with this sensor.
Read the operating instructions carefully before installing and operating this sensor.
Keep the cable connections dry and free from contamination during installation.
Keep the sensor away from high voltage cables.
3.2 Electrical installation
Only suitably qualified personnel or a competent person may install, operate or repair this equipment. The
installer must ensure all electrical installations comply with local wiring regulations and standards (refer to
BS7671 for UK installations).
Please check the sensor has been wired correctly. Incorrect wiring may causes damage to the sensor or
monitor.
The WaterWatch² family of sensors are designed exclusively for use with the 7300w² Monitor. DO NOT
connect to other monitors.
Sensors may need to be correctly addressed to the monitor before use. Please read the
Sensor
Configuration
section of this manual for full details.
3.3 Operating
Because these sensors have a wide range of applications, users must acquire the appropriate knowledge to
use these sensors in their specific application.
Partech are always available to provide advice and assistance in your application. Please contact Partech for
further information.
These sensors may need to be calibrated before use. Please read the
Calibration
section of this manual for
full details of calibration procedures.
3.4 Service and Maintenance
Before maintenance, this equipment must be isolated or disconnected from HAZARDOUS LIVE voltages
before access.
Maintenance instructions for the TurbiTechw² sensor should be carried out as specified in this instruction
manual. Failure to carry out regular maintenance could invalidate the Warranty.
Services and repairs must be carried out by a Partech engineer. Partech can provide a service contract for
your system. Please ask for details.
Page 8 of 34
225769IM - Issue - 05 Issue Date 30/04/2019
