TurbiTechw² LR Instruction Manual
8 Measurement Configuration
The monitor leaves the factory without any measurements configured. Measurements can only be
added after installing the relevant sensor(s).
Once the sensor(s) have been registered with the monitor and installed, the measurements will now be
available.
8.1 Measurement Config
From the MAIN MENU screen, select MEASUREMENT CONFIG by
pressing
, press
. The screen shot to the left shows the default
configuration after the installation of the TurbiTechw² sensor on a single
sensor configuration:
M:01
= Turbidity (NTU)
8.1.1 Measurement Status
This option allows the user to review the current status of the 16 measurement channels, these will all
be set to disabled until a sensor is added. In the example above the first channel will be occupied.
Once a measurement has been configured the display will be updated to indicate the measurement
and it's status.
8.1.2 Add Measurement
Unless a measurement has been removed there would be no condition
where the 'Add Measurement' option is required as the only measurement
type is Turbidity (NTU) which is selected by default when a sensor is
installed. The following description is included for the purposes of
completeness.
Note the screenshot on the left shows 'Measurement
Config' with the Turbidity sensor removed.
1. The MEASUREMENT MENU should be displayed. Press
to highlight ADD MEASUREMENT,
and press
.
2. All available measurements will be displayed in a list. Press
or
to select the first
measurement. Note Colour (HU) is the only option.
3. Press
to select the measurement. Repeat the process if more measurements are required.
4. Each measurement will be allocated a measurement number from M:01 – M:16. A total of 16
measurements may be displayed.
5. Press
to return back to the display screen. Your first
measurement configured should now be displayed. If two
measurements were configured, press
to cycle through the
display screens to show 2 measurements, 4 measurements etc.
The Measurement Menu will list all configured measurements in order M:01
to M:16 the list will also indicate the sensor number that is delivering the
signal for the measurement.
225769IM - Issue - 05 Issue Date 30/04/2019
Page 19 of 34
MEASUREMENT CONFIG
Measurement Status
Add Measurement
M:01 Turbidity (S:01)
MEASUREMENT CONFIG
Measurement Status
Add Measurement
MEASUREMENT CONFIG
Measurement Status
Add Measurement
M:01 Turbidity (S:01)
