Control Surface Travel Measurement
Factory Setting for Control Surface Travel
Factory settings for the DX5e transmitter are Dual rates set at
100% on high rate and at 70% on low rate. These dual rates cannot
be changed on the DX5e. All controls surfaces are set for 100%
adjustable travel volume (ATV).
The factory settings provide a moderate amount of control surface
movement. Clevises are installed in the outermost holes of the
control horns (away from the control surface).
Note: Measurements are made at the widest point of each control surface from the neutral position for each control surface.
Note: These settings have a tolerance of plus or minus 1 mm.
Factory Setting for Rudder and Elevator
Servo Arms and Pushrods
Front of
aircraft
Elevator
Servo
Rudder
Servo
Low Rate
High Rate
Aileron 10mm up/7mm down 1
mm up/1
mm
down
Elevator
10mm up/down
15mm up/down
Rudder 17mm left/right
22mm left/right
1/2 Flap
Full Flap
Flap
15mm
25mm
EN
12
13
