10
Parker Hannifin Corporation
Tube Fittings Division
Columbus, Ohio
http://www.parker.com/tfd
Parflange ECO 25
Hydraulic Flanging and Flaring Tool
90
˚
Flanging Information for Seal-Lok Fittings
Step 4: Raise the tube stop and install the flanging pin into the
main spindle head of the machine. Be sure to lower
the tube stop to its original position after inserting the
pin.
Step 5: Using the LB-2000 lubricant for steel or Pro-Form 858
lubricant for stainless steel, adequately lubricate the
flanging pin as well as the inside diameter of the tube
end.
It is very important to lubricate the Flanging
Pin and Inside Diameter of the tube end prior to
each flanging operation.
Step 6: Insert the bottom half of the die set (either die half can
be used) into the die cavity of the machine using the
keyways on either side to secure the die.
Ensure that
the 90° Flange side of the die half is facing toward
the main spindle head of the machine (away from
the operator).
Step 7: Place a Parflange mechanical sleeve (part number
TPL) onto the end of the tube with the widest part of the
sleeve facing the end of the tube you intend to flange.
Place the sleeve and tube assembly into the bottom
half of the die set, ensuring the Parflange sleeve is
placed into the corresponding cavity in the die half.
Step 8: Insert the top half of the die set into the die cavity on
top of the other half, also ensuring that the 90° Flange
side of the die half is facing toward the main spindle
head of the machine.
Step 9: Set Tube Stop adjustment dial to recommended value
for flanging the O.D., wall thickness and material of
the tubing you are using (See Chart on page 8). Dial
settings are recommendations only and may require
adjustment to obtain desired results.
