LX80L Series Product Manual
39
Parker Hannifin Corporation
EMN Automation - Parker
Irwin, Pennsylvania
Y-Axis Cable System
Step 2:
Remove endblock cover/
strain relief by removing four (4)
socket head cap screws on the Y-
axis.
Step 1
: Remove power from the table and allow time for the base and carriage to reach room tem-
Step 3:
Disconnect all three (3) cables that are attached to the end-
block pc board.
Step 4:
Connect the three (3) cable plugs of the Y-Axis Cable Sys-
tem to the corresponding sockets in the endblock pc board.
Step 5:
Attach the Y-Axis Cable System mounting block with two
(2) socket head cap screws to the positioner endblock.
Take spe-
cial care not to pinch wires when assembling parts.
Step 6:
Attach the Y-Axis Cable System cover using four (4) socket
head cap screws to the Y-Axis Cable System mounting block.
Take
special care not to pinch wires when assembling parts.
When using two LX80L positions in an X-Y configuration care must be taken with the cable management of
the Y-axis extension cables. These cables will need to flex through the entire travel of the X-axis positioner.
To help eliminate these flexing issues, Daedal has developed a
Y-Axis cable System
. This system comprises of
an adapter block that replaces the cable side endblock cover, a cable system with cable carrier, and an end-
block attachment assembly, that is mounted to the X-axis mounting surface. See following pictures and in-
structions.
Summary of Contents for LX80L
Page 56: ......
