Introduction
Compact Linear Actuator - LCB
10
192-510014 N06 April 2013
1.6
Warranty conditions
User Conversions and Changes are Not Permitted
The linear actuator must not be changed in its design or in terms of safety without
our approval. Any change as defined here made by the user excludes any liability
on our part.
1.7
Conditions of utilization
General introductory notes
With this linear actuator you bought a product which was manufactured and tested
before delivery with the utmost care.
Please take your time to read the following notes which you ought to follow closely
during setup and operation.
The operation of the linear actuator is only permitted within the range of the limit
values stated in this manual.
Unless, all claims under the warranty will become void and a reduced service life
or even damages must be expected.
Please compare the operating data with the stated limit values especially
with reference to:
Stroke length and setting of the limit switches, those must be set so that there is a
sufficient safety travel at both ends of the travel stroke
Even if the limit switches were already mounted at our premises, they must be
adapted according to suitable values before operation!
Speed
Acceleration
Environmental conditions (e.g. temperature, contamination)
Please do take possible pulses caused by moved masses into consideration for
the operating data.
Note on the installation of the linear actuator
Do always use all available mounting possibilities and respect the requirements
listed in chapter "
Preparations for substructure
(see on page 11)",
"
Fitting/mounting
(see on page 12)".
If the motor used with the linear actuator should be able to exceed individual limit
values, the respective values for the motor must be limited in the control by
appropriate parameterization. The parameterization should even be reduced down
to the values necessary for operation.
The externally mounted end stops of the linear module may under no
circumstances be accessed during operation. The end stops are only intended for
safety purposes.
The lifetime of the linear actuator depends strongly on the degree of power
exploitation and on impermissible operating states occurring - even if only for a
short time.
