Easy Start Guide
6. How to set a Parameter value
Page 6
All content, including but not limited to graphics, text and procedures copyright
The Inverter
Drive Supermarket and must not be reproduced or altered without prior written permission.
©
This guide has been produced by The Inverter Drive Supermarket Ltd.
Parker AC10 Series Inverter (to 22kW)
The parameter list is prefixed with “F” as illustrated (left).
With the motor stopped, press the “M” key repeatedly until the
parameter list is shown.
6.1 Press “M” key to access parameters.
Press the “0” (stop) key to select the first (left) digit. This represents
the parameter group (F100, F200, F800 etc.)
Note: In parameter “group” mode, the “DGT” (digit) lamp is not
illuminated.
6.2 Select the required parameter “group”.
Use the up and down keys to select parameter group F800.
6.3 Select the required parameter.
Press the “0" (stop) key to select the last two (right) digits. This
represents the parameters within the group.
Use the up and down keys to select parameter F803 (Rated Motor
Current in Amps). Press the “E” key to edit the parameter value.
Note: In parameter mode, the “DGT” (digit) lamp is illuminated.
The display will show the current parameter value. Use the “0" (stop)
key to select a digit (it will flash when selected). Use the up and
down keys to increase or decrease the value as required. In this
example we will set the value to 2.4.
Press the “E” key to save the new value. The display will return to
the parameter list as illustrated in 6.3 above.
6.4 Change the parameter value and save.
