1 - Safety
StradaPAL – Installation manual
6/43
Electricity
Any work on the product may only be performed by appropriately trained personnel.
Only correctly trained persons may work on the power supply.
Protect personnel from electrical shocks with the help of appropriate electrical and earth
connections.
Always switch off the power before beginning some repairs, as instructed in this guide.
Make sure that the electrical parts are installed in accordance with national standards.
Keep the mains power supply disconnected throughout these operations. Protect all
electrical wires from the rain. Never undertake repairs on equipment connected to the
mains or the telephone network during thunderstorms.
While repairing a circuit breaker installed in a machine, the main circuit breaker located in
an equipment room must be disconnected and a
maintenance board
is to be put up to
protect the worker from electric shocks.
Isolate the mains power supply with a cut-out and switch off the low voltage with the on/off
button of the main board.
Make sure that the earth cable is in good condition.
Follow the instructions relating to the earth connections of product components in order to
ensure compliance with EMC immunity and emissions standards.
The earth conductor that protects the power cable must be green and yellow.
Minimum section of the incoming mains cable: 2.5 mm² (AWG 12).
Depending on the country of installation, the equipment may be connected to a single-phase
230V IT network.
Ask for a signed certificate from the contractor.
Mechanical parts
Always remove any metal jewellery (rings, bracelets and wristwatches) before servicing the
electrical parts (power supply, battery, wiring) or beginning work on or close to moving
parts.
Keep your hands away from moving and sharp parts, door hinges and locks, wheels and
blades.
Take care not to hurt yourself with the open door or any other projecting parts or parts
fixed on the terminal.
Temperature
Always wait for a few minutes after turning the Pay & Display machine off before you start
working close to hot areas of the intermittent heating devices.
