5
LT6488 issue 1 (06/13)
Paragon P6Users Instructions
SECTION ONE Introduction Continued
Care must be taken to prevent any damage being caused to surrounding soft furnishing or
decoration; e.g. many embossed vinyl wall coverings may become discoloured if placed too close
to the appliance. Combustible material i.e. wall panelling or wallpaper must be removed from
behind the fire and fire fascia.
It is advised that this appliance is serviced annually; as it is more likely to provide trouble-free
operation.
In GB (Great Britain) the fire does not normally require purpose built ventilation, but if for any
special reason purpose built ventilation is provided it should be checked periodically to ensure
freedom from obstructions.
In IE (Ireland) permanent ventilation must comply with the current edition of IS813.
SECTION TWO Operating the Appliance
Before operating the appliance the battery must be fitted to the spark generator. The generator and
boot connection is located on the base of the fire box on the left hand side. Connect the battery to the
boot connect and place the battery directly under the spark generator unit.
The full lighting procedure is as follows: -
a.
Push slide control lever in,as far as possible a clicking noise will be heard and the pilot will
light, PUSH FIRMLY FOR ABOUT 20 SECONDS.
b.
Allow the lever to spring back the pilot light should remain alight and the main burner should
light on its low setting.
c.
Should the pilot fail to light, pull the lever fully out to turn off the appliance, wait 3 minutes and
repeat the procedure(a &b).If the pilot does not light and no clicking noise is heard replace the battery
and try again.
d.
After lighting the pilot flame and the main burner on its low setting the control lever may be
pulled out until slight resistance is felt, this will put the burner on its high setting.
e.
To completely extinguish the fire, pull the lever out to its fullest extent.
f.
The fire may be operated on either its low or high setting.
g.
It is recommended that the appliance is operated on its high setting for a period of 10 minutes
before adjusting to the low setting.
h.
If the ignition does not operate fit a new 9V battery (PP3/MN1602) to the ignition unit, This is
located on the base of the fire box RH side.
Note: -
If the ignition fails the pilot can be lit with a taper or a match held at the pilot head.
