3. Status and Statistics
3-28
May
2003
9000-A2-GB33-20
Permission Denied
(Seen at an FTP
terminal.)
A file transfer was
attempted, but the:
User did not have Level
1 security.
Wrong file was specified
when the
put
command
was entered.
User attempted to
upload a program file
from the unit.
See your system administrator
to get your security level
changed.
Try again, entering the correct
file with the
put
command.
Enter the
put
command
instead of a
get
command; you
can only transfer files to the
unit, not from it.
See
Upgrading System
Software
in Chapter 4,
Operation and Maintenance
.
Please Wait
Command takes longer
than 5 seconds.
Wait until message clears.
Port Inactive
(iMarc SLV 9128-II
only)
The port is disabled, or it
supports synchronous data
when a DTE Loopback was
started.
No action is needed.
Resetting Device,
Please Wait ...
Yes (or y) was entered in
the
Reset COM Port usage
field of the System Paused
menu.
No action needed.
Save Cancelled
(iMarc SLV 9128-II
only)
Changes were made on the
Easy Install screen, but
when it came to saving the
changes, the Esc key was
pressed or No was entered
in response to the
Save
Changes?
prompt.
No action is needed.
Test Active
No higher priority System
and Test Status messages
exist, and a test is running.
Contact service provider if test
initiated by the network.
Wait until the test ends and
message clears.
Cancel all tests from the Test
screen (Path: main/test).
Stop the test from the same
screen the test was started
from.
Table 3-4.
Device Messages (5 of 6)
Message
What It Indicates
What To Do
