5. Troubleshooting
5-48
May
2003
9000-A2-GB33-20
IP Ping Test
An IP Ping test can be run to test connectivity between the iMarc unit and any
iMarc unit, router, or NMS to which it has a route.
Times when you might want to run an IP Ping test are:
To test connectivity between the iMarc unit and any iMarc unit in the network
to verify that the path is operational. Select
IP Ping Test – Procedure 1
on
page 5-53 to ping any far-end iMarc unit.
To verify the entire path between a newly installed remote site iMarc unit and
the central site NMS. During a remote-site installation, an IP Ping test is
typically run from the remote site to ping the NMS at the central site. The
remote iMarc unit must have SNMP trap managers configured, and one of
those trap managers must be the central site NMS. Select
IP Ping Test –
Procedure 2
on page 5-54 to ping the NMS at the central site.
To test the path to the NMS trap managers during installation of the central site
iMarc unit. The remote iMarc unit must have configured the SNMP trap
managers to be sent the ping. Select
IP Ping Test – Procedure 2
on page 5-54
to ping SNMP trap managers.
Ping Screen Example
main/test/ping 9128-II
Device Name: Node A 12/05/2002 06:02
IP PING
Target IP Address: 000.000.000.000
Destination Interface: Use Internal Route DLCI: 100 (Net1-ATM 15,255)
Source IP Address: Special 135.90.25.1
Encapsulation: Routed
TOS Byte User Defined 001101
Packet Size: 64
Iteration Count: 1
Inter-ping Delay (sec): 5
Response Timeout (sec): 2
Start
---------------------------------------------------
Status: Alive
Transmit Receive Lost Loss Ratio
Pings: 000000 000000 000000 0000 %
Current Minimum Maximum Average
Roundtrip Delay (ms): 0000 0000 0000 0000
--------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu MainMenu Exit
