AIM2-A2-GZ40-20
May 2005
5
2. With the AIM24000 Printed Circuit Board (PCB) facing right and the AIM24000
model name on the lower edge of the faceplate, align the upper and lower
edges of the PCB with the slot module guides.
3. Slide the AIM24000 into the chassis until it is fully seated. Do not use
excessive force.
4. Tighten the fastening screws on the AIM24000 faceplate by turning them
clockwise with a screwdriver, just until snug. Do not over-tighten the fastening
screws.
4-Slot BLC
The 4000 and 4000E are five-slot chassis. Slots 1–4 are reserved for interface
modules (such as the AIM24000), and the remaining slot (slot 5 in the 4000 and
slot U1 in the 4000E) is reserved for a management module.
NOTE: Although the AIM24000 can be installed in both the 4000 and the 4000E
BLCs, the 4000 has the capability to support AIM24000 ports 1–24 only; in order
to make use of all 48 ports, you must install the AIM24000 in a 4000E.
Procedure
To install the AIM24000 in a 4-slot BLC:
1. Select a slot for installation. The AIM24000 may be placed in any slot, 1–4.
Remove the blank plate from the chosen slot by turning the fastening screws
counter-clockwise with a Phillips screwdriver and then gently sliding the blank
plate out of the chassis
CAUTION: If a blank plate is removed from slot 1–4 on a 4000 or 4000E BLC,
it must be replaced with an interface module.
Do not operate your BLC with
an empty slot.
