HOW TO CUT 3mm LETTERS ?
• To obtain good quality output, narrow width media is suggested. However, if wide media is used, you
should:
1.
Position two pinch rollers as close as possible to both edges of the cutting area.
2.
Make sure the loaded media is held fl at with equal tension across the platen.
3. Suggested
operation
settings:
Tool force: 55 gf. (or depending on the material)
Cutting speed: 45-50 cm/sec
Tool up speed: 45-60 cm/sec
Smooth cut: Disable Cutting
Quality: Small Letter
HOW TO MAKE A LONG PLOT?
•
When you are making a long plot with a roll of heavy and wide vinyl paper you need to use
AUTO UNROLL MEDIA function ( see page 41 ) :
1.
If the length of graphic is between 6 feet, the cutting speed is better slower than 45cm/sec and the
cuting quality is set as Normal.
2.
If the length is longer than 10 feet, the CUTTING SPEED is better slower than 30 cm/sec.
3.
After loading the roll media all pinch rollers are raised at this stage, fl atten the media on the platen and
hold the front edge of the roll media fi rmly. (See Figure 0-1)
Then turn the roll downward to make an equal tension across the media (See Figure 0-2)
Make sure that the media tension
is equally distributed from left
to right. If the media is not tight
enough against the platen, it will
cause tracking problems.
Figure 0-1
Figure 0-2
A. Advanced Troubleshooting III
