This chapter describes the button operation with the LCM menu fl owcharts of Panther II. When the cutting
plotter is ready for use as described in Chapter 1 & 2, all functions are under default parameters.
4.1 Setting up Menu—Panther II in on line mode
4. Operation Procedure
Power On
Firmware V-.--
Copyright 2002
Initializing ---cm
Cutter please wait
Place Media and Lower down the
lever
Roll
Edge Single
Key Key Key
Sizing Media Width
Lever Up to Abort
Sizing Media Length
Lever Up to Abort
S---.- F ---.- O -.-- M
L :-----.-- W : ----.--
Top Menu
Sending data
Data in Processing
Pause
Setup Resume
Force: 80 gf
OK: Enter
Speed:
72 cm/s
Select:
OK:Enter
Up Speed:
72 cm /s
Select:
OK: Enter
Quality:
Normal
Select:
OK: Enter
[ Force Key]
[Speed Key]
[Offset Key]
[Data Clear]
[Tool Select]
Use to
select;
Panther II in processing
Use
to
select
[Pause]
Media Check
Offset: 0.275 mm
OK: Enter
Clear data memory
N: Cancel OK: Enter
1S:72 F:80 O:0.276 M
Select OK: Enter
Set Smoothing Cut
Select:
OK: Enter
Over Cut:
0.00mm
Select:
OK: Enter
Set Tangetial Mode
Select:
OK: Enter
Pouncing 0.00mm
Select:
OK: Enter
Panel Setup
Select:
OK: Enter
Restore default?
Select:
OK: Enter
Save parameter?
Select:
OK: Enter
4. Operation Procedure 4-1
[Enter] to
enable the
setting
