4.4 Loading the Sheet Media
To load the media properly, please follow the procedures listed below:
Step 1
Use the lever on the upper right side of the cutting plotter to raise or lower down pinch rollers. Pull the lever
forward until it makes a clicking sound then the pinch rollers are raised (Figure 4-17).
Figure 4-17
[Cut Test]
Square Cut
This performs a cutting test at the present blade
position.
For more information, please refer to 2-7
adjusting the blade force and cutting speed.
Recut/ Copy
Allows user to repeat the last job without
sending the fi le again.
Setting Range:
For Recut:1-99 with an increment of 1.
For Copy: 1-99 with an increment of 1.
It will leave 1mm between each copy.
Note: If the media is not large enough to
continuous copy, it will show as following.
If both functions are selected at the same time,
the cutter only executes the last setting.
Mark Positions
(for contour
cutting)
This feature is making contour cutting on the
images that were generated by printers. The
registration marks should be printed along the
border of the image. Panther II provides two
alternatives.
1. 2-points registration contour cutting
2. 3-points registration contour cutting
O u t O f S p a c e ; #
o f C o p i e s F i n i s h e d
4. Operation Procedure 4-6
Lever
