Step 4
Position the stand beam perpendicularly to part
2
and put the screws into the holes and tighten them as Figure
2-3. Then the complete picture of stand will be like
Figure 2-4
.
Screws
1
H-stand
3
Stand
2
Stand
Figure 2-4
Figure 2-3
Step 5
Remove the cutting plotter from the carton. Position your stand under the plotter, and then insert the screws into
the holes on plotter’s bottom and tighten them up
as shown in Figure 2-5.
Screw
Figure 2-5
Note:
The serial number for your cutting plotter is on the
underside of the machine. Record this serial number on
the front of this manual or other secure location for future
reference.
Step 6
Insert the roll holder support with the screws into the holes of the
stand, then tighten them up as shown in Figure 2-6. You could decide
roll holder support’s position by inserting into different holes.
Figure 2-6
6 Screws holes
Roll holder support
4 Screws
2. Installation 2-3
