5
USER mAnUAl
Control
Control of the vehicles zones depends on the type of connection and system settings, original car
operation and trim.
TYPE №1
Analog connection – It is a direct connection of analog inputs and outputs to electrical
circuits of a vehicle in accordance with a connection diagram.
TYPE №2
Digital connection – It is a connection to digital (CAn, lIn) buses. It allows reading
information (statuses) and controlling vehicles (commands) by digital buses of the vehicles. The detailed
information about digital protocols is available on loader.pandorainfo.com. The declared statuses may
not be available for certain vehicle trims.
TYPE №3
Built-in sensors – These sensors are integrated in the base unit. The sensors perform
control and protection of the vehicle. Additional connections are not required.
TYPE №4
Additional sensor (*optional) – External additional sensors are connected to the base unit.
TyPE
Protected and monitored zones
№1 №2 №3
№4
•
•
•
*
Interior temperature (status)
•
•
Engine temperature (status)
•
•
*
outside sensor (status)
•
Voltage of the on-board circuits (status, security zone – alarm level)
•
Shock sensor (security zone – alarm and warning level)
•
motion sensor (security zone – alarm level)
•
Tilt sensor (security zone – alarm level)
•
•
*
oE alarm system status via CAn, additional sensor, (status, security zone –
alarm and warning level)
•
•
Turning ignition on (status, security zone – alarm level)
•
•
opening doors, separate indication for each door via CAn (status, security
zone – alarm level)
•
•
opening a trunk (status, security zone – alarm level)
•
•
Pressing brake (status, security zone – alarm level)
•
•
Engine operation control - RPm (status)
