29
USER mAnUAl
• An original key must be in radio coverage zone. To start the engine press the LOCK button 3 times
within 5 seconds.
NOTE! T
hE
“E
NgiNE
sTarT
usiNg
aN
OrigiNal
car
kEy
”
fuNcTiON
wOrks
wiThOuT
addiTiONal
sETTiNgs
. a
vailabiliTy
Of
ThE
fuNcTiON
dEpENds
ON
a
spEcific
car
mOdEl
.
NOTE! E
NgiNE
sTarT
prOcEdurE
dOEsN
’
T
wOrk
wiThiN
20
sEcONds
afTEr
armiNg
. y
Ou
caN
sTarT
ThE
ENgiNE
usiNg
aN
OrigiNal
car
kEy
afTEr
This
dElay
.
• To stop the engine press the LOCK button 3 times within 5 seconds.
Mobile application
•
To start the engine, open the mobile application. When the system is online (you are in the radio
coverage area), press and hold the START EnGInE button to start the engine until the scale is fully
loaded. The engine will be started in a few seconds, the spinning icon will confirm engine running.
•
To stop the engine, open the mobile application. When the system is online (you are in the radio
coverage area), press and hold the SToP EnGInE button to stop the engine until the scale is fully
loaded. The engine will be stopped in a few seconds, the spinning icon
will be faded.
Automatic engine starts
The system allows configuring automatic engine start and stop conditions. Automatic starts can be
configured using a remote control or mobile application. The following conditions can be specified for
automatic engine starts: schedule, time period, engine temperature, voltage. The engine will be stopped
automatically after specified time or when the engine temperature reaches a specified value. The engine
can be also stopped by a user command.
NOTE! a
uTOmaTic
ENgiNE
sTarTs
aNd
sTOps
by
TEmpEraTurE
arE
availablE
ONly
if
a
TEmpEraTurE
sENsOr
is
cONNEcTEd
.
T
hE
sENsOr
availabiliTy
dEpENds
ON
ThE
sysTEm
sET
.
SERVICE moDE
It is recommended to put the system into the service mode before handing it to a car service or valet
parking. When this mode is switched on, security system stops interfering with built-in electronics and
disables all functions to ease maintenance.
To switch on this mode, disarm the system, switch on the ignition, a radio tag must be in
the coverage zone, enter the “Immobilizer PIN-code” (if the “Code immobilizer” function is
implemented):
