Install DCT Hand Sanitizer Dispenser
2 of 2
Align the dispenser
against the
anchored mounting
hole(s). Push to
adhere the
dispenser tape to
the wall.
Attach (1-3) screws
to secure the
dispenser to the
wall using the nut
driver or drill and nut
driver.
NOTE
NOTE
: P&G tech will
install more screws at the
hand soap dispenser
during a follow up routine
PM visit if needed.
Close the cover.
Apply the DCT
Hand Sanitizer label
by centering it
across the width of
the dispenser
between the cover
window and gray
push bar.
Install Drip Tray
Install the drip tray
by sliding the top
edge of the drip tray
under the dispenser
before securing the
drip tray to the wall.
Mark (2) new holes
with a pen or
marker.
Drill the marked new
holes with a drill and
drill bit.
Tap the wall anchor
into the holes using
a hammer. Ensure
the anchor is flush
to the wall.
Attach (2) screws to
secure the drip tray
to the wall using the
nut driver or drill and
nut driver.
Prime the Dispenser
Open the cover by
locating the white
cover release under
the dispenser. Then
push UP
push UP
on the
release to open.
Locate the DCT
Hand
Sanitizer product
box. Tear the
perforated tab and
pull the nozzle out.
Install a fresh DCT
Hand Sanitizer box
into the dispenser.
Confirm the white
tip of the nozzle is
properly positioned
into the correct
location.
Close the cover.
Push the gray push
bar 2-3 times until
you see a dose of
hand sanitizer.
8
8
9
9
10
10
11
11
12
12
13
13
14
14
15
15
16
16
17
17
18
18
19
19
20
20
©2020 Procter & Gamble. All Rights Reserved. Unauthorized reproduction prohibited. (Last Updated: 09/09/2020)
