Operating
Instructions
General Specifications, Model 450
General Specifications,
Model 450
Size (Approx.):
14.58W x 12.38H x 18.50D
Shipping Weight:
24 lbs (10.9 KG)
Electrical:
110/120VAC, 50/60HZ,
4 AMP FUSE
take-a-label.com
•
• 16900 Power Dr., Nunica, MI 49448 • 616.837.9300
Note:
The TAKE-A-LABEL dispenser is shipped
mounted to a base to prevent shifting in the container.
1. Remove the machine from the base.
**Always load the TAKE-A-LABEL dispenser with
the On-Off Switch in the (OFF) position.**
2. To load a roll of labels on the TAKE-A-LABEL,
loosen the unwind hub screw (57) on the unwind
collar (56) and remove the collar, unwind washer,
unwind spring, and disc from the unwind shaft.
3. Place the roll of labels on the unwind shaft between
the two unwind discs. Place the roll with the begin-
ning of the roll on the bottom with the web dispens-
ing to your right as you face the side of the machine.
4. Replace the unwind disc, unwind spring, and collar
onto unwind shaft. If using labels on a 3” diameter
core, the hub on each disc will fit inside the core
and support the roll of labels. If the labels are on a
1” core, simply slide the disc up snugly against the
roll of labels. When the disc is in place, tighten the
unwind hub screw against unwind shaft.
5. Thread the loose end of labels under and up the
front of the peel plate.
6. Pull the labels over top of peel plate far enough to
reach the waste take-up roll.
7. Remove the waste wind clip, thread label backing
paper under clip, and reinsert clip over loose paper.
8. Position the Photo Eye or Micro Switch Assembly by
loosening wing nuts and moving assembly to right
or left so that the sensor is at or near the center of
the labels. The Photo Eye or Micro Switch Asembly
can be tilted forward or backward by loosening the
mounting bracket vertical adjustment wing nut.
9. Turn on On-Off switch. The waste wind shaft will
turn, winding up backing paper and dispensing a
label at the top of the peel plate. When the Photo Eye
or Micro Switch senses the dispensed portion of the
label, the motor will stop. As each label is removed,
the machine will operate until the next label is in
position to be removed.
(CAUTION:) Turn off
switch before removing wound up waste.
10. If labels tend to follow backing paper over the top
of the peel plate instead of peeling off, then there
is insufficient tension on the web of the labels. The
shaft adjustment collar should be moved in to put
more tension on the web.
11. If the motor stalls it may be necessary to move
the shaft collar out to reduce the amount of
unwind tension.
Operating Instructions for the TAKE-A-LABEL Model TAL-450-18
