-35-
8. Motion Detector Setting (MOTION DET)
The motion detector detects the moving objects in the
scene by monitoring changes in brightness level. You
can select the level of sensitivity for motion detection.
When this camera is connected to a compatible intelli-
gent CCTV system, the camera transmits an alarm sig-
nal by multiplexing it with the video signal.
1. Move the cursor to the MOTION DET parameter
and select ON.
2. Press
I
. The MOTION DETECT menu appears
on the monitor screen.
** MOTION DETECT **
LEVEL ....I....
- +
DISPLAY MODE
ALARM ON
MASK SET
RET END
↵
↵
3. Move the cursor to MASK SET and press
I
.
MASK SET lets you set 48 mask areas. To set
MASK SET, proceed as described in steps 2 to 4
of “ALC mode with SUPER-D2 OFF and ELC
mode”.
4. Move the cursor to the ALARM parameter and
select ON or OFF to set the alarm for DISPLAY
MODE.
Note:
When the system controller WV-RM70, WV-
CU550, WV-CU550A, or WV-CU151 is used
with this model, select OFF for ALARM.
5. Move the cursor to DISPLAY MODE and press
I
to see the current setting. The masks that detect
the brightness changes start blinking.
6. To raise detection sensitivity, press
I
to return
to the MOTION DETECT menu.
7. To obtain the optimum detection level, move the
“I” cursor to adjust the level.
8. Repeat the procedures above to obtain a satisfac-
tory setting.
Notes:
• Masking or adjusting the detection level is needed
to prevent malfunction under the following condi-
tions:
• When shooting an object under flickering fluores-
cent light or shooting in ELC.
• When leaves or curtains etc. are swayed by the
wind.
• When the object is lighted by lighting equipment
that constantly turns on and off.
• It takes about 0.2 seconds for the alarm signal to
reach the alarm terminal of the VTR after the cam-
era detects the object.
