-33-
• To reset COARSE and FINE to the values pre-
set at the factory, press
L
or
M
simultane-
ously. COARSE and FINE adjustments are
preset at the factory to zero-crossing of the
AC line phase.
• If the AC line contains noise (spike noise,
etc.), the stability of the vertical phase of the
camera video output signal may be disturbed.
7. White Balance Setting (WHITE BAL)
7-1. Auto-Tracing White Balance Mode (ATW)
You can select one of two modes for white balance
adjustment as follows:
• ATW (Auto Tracing White Balance)
In this mode, the colour temperature is monitored
continuously and thereby white balance is set
automatically. The colour temperature range for
the proper white balance is approximately 2 600 -
6 000K. Proper white balance may not be obtained
under the following conditions:
1. The colour temperature is out of the 2 600 -
6 000K range.
2. When the scene contains mostly high colour
temperature objects, such as a blue sky or
sunset.
3. When the scene is dim.
In these cases, select the AWC mode.
Move the cursor to the WHITE BAL parameter and
select ATW. The white balance of the camera is
automatically set.
• Automatic White Balance Control Mode (AWC)
In this mode, accurate white balance is obtained
within a colour temperature range of approximate-
ly 2 300 to 10 000K.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON
SENS UP OFF
SYNC INT
WHITE BAL AWC
→
PUSH SW
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
↵
↵
1. Move the cursor to the WHITE BAL parameter and
select AWC
→
PUSH SW.
2. Press
I
to start the white balance setup. The
PUSH SW is highlighted to indicate that the white
balance is being set.
3. When the white balance setting is completed, the
PUSH SW returns to normal display.
