i
Left Button (
)
This button is used to move the cursor to the left. It also selects the mode and can be
used to adjust some levels.
o
Up Button (
)
This button is used to move the cursor upward. It is also used to select items in the
CAM SET UP menu.
!0
Set Button (
)
This button is used to activate an item selected in the CAM SET UP menu.
!1
Selector (NC)
This selector is not used on this camera.
!2
Detail Level Selector (SOFT-SHARP)
This selector is used to select the detail / aperture level as follows.
SOFT:
When a quad system is connected to this camera, select this position.
SHARP:
Select this position usually.
!3
Microphone Selector (MIC OFF-ON)
Select ON or OFF as needed.
!4
Microphone
!5
Power indicator
This indicator lights up when the power of this camera is on.
!6
Monitor Output Connector (MONITOR OUT)
This connector is used to connect with the video input connector of the monitor.
!7
Video Output Terminal
This terminal is used to connect with the video input connector of the monitor.
!8
Rear Cover
The rear cover can be removed to gain access to the terminal.
6. High quality picture:
(a) 2H type vertical enhancer for greater picture sharpness
(b) Chroma averaging circuit for better colour signal-to-noise ratio
(c) Minimum of aliasing on fine objects
(d) Expanded dynamic range by use of knee circuit
(e) Highlight aperture correction for greater picture detail of bright objects
7. Ability to shoot indoor scenes with fixed iris lens by use of Electronic Light Control (ELC)
function.
8. Sound around the camera can be monitored by built-in microphone.
5. Clean the CCD faceplate with care.
Do not clean the CCD with strong or abrasive detergents. Use lens tissue or a cotton
tipped applicator and ethanol.
6. Never face the camera towards the sun.
Do not aim the camera at bright objects. Whether the camera is in use or not, never
aim it at the sun or other extremely bright objects. Otherwise, blooming or smear may
be caused.
7. Do not operate the camera beyond the specified temperature or humidity.
Use the camera under conditions where temperature is between –10°C - +50°C (14°F -
122°F), and humidity is below 90%.
Rear Panel
