Panasonic Workio DP-1520P, Service Manual

Page: 209 / 496

209
SEP 2004
Ver. 1.2
DP-1520P/1820P/1820E
012 DTMF Level 00 = 0 dBm
~
15 = -15 dBm Selects the DTMF output level, 0 to -15 dBm in 1
dBm steps.
013 G3 RX EQL 1 = 0dB
2 = 4dB
3 = 8dB
4 = 12dB Selects the cable equalizer for G3 reception mode,
0dB, 4dB, 8dB or 12dB.
014 G3 TX EQL 1 = 0dB
2 = 4dB
3 = 8dB
4 = 12dB Selects the cable equalizer for G3 transmission
mode, 0dB, 4dB, 8dB or 12dB.
015 ~
016
Not Used
017 TX Start 2400 bps
4800 bps
7200 bps
9600 bps
TC7200
TC9600
12000 bps
14400 bps Selects the transmission modem start speed,
14400/12000/TC9600/TC7200/9600/7200/4800/
2400 bps.
Press “V” or “/\ “ to select the symbol rate.
Note:
This parameter is applicable only when
communicating with regular G3 machines. When
communicating with Super G3 (V.34) machines,
use Parameter No. 32.
018 RX Start 2400 bps
4800 bps
7200 bps
9600 bps
TC7200
TC9600
12000 bps
14400 bps Selects the reception modem start speed, 14400/
12000/TC9600/TC7200/9600/7200/4800/2400 bps.
Press “V” or “/\ “ to select the symbol rate.
Note:
This parameter is applicable only when
communicating with regular G3 machines. When
communicating with Super G3 (V.34) machines,
use Parameter No. 33.
019 ITU-T V.34 1 = Off
2 = On
3 = Select Selects whether the ITU-T V.34 is Off, On or Select.
Select : Select whether the ITU-T V.34 is Off or On,
when entering Phone Book Dialing
Numbers or Manual Number Dialing.
020 ITU-T ECM 1 = Off (Invalid)
2 = On (Valid) Select the ECM mode.
021 EP Tone 1 = Off (without EP Tone)
2 = On (with EP Tone) Selects whether to add the echo protect tone on
V.29 mode.
(Used when Echo Suppression is disabled.)
On : Add
Off : Do not add
022 Signal Interval 1 = 100 ms
2 = 200 ms
3 = 500 ms Selects the time interval between the receiving
signal and the transmitting signal.
023 TCF Check 1 = Normal (Short)
2 = Long Selects the TCF check interval Long/Short
024 CED Frequency 1 = 1080 Hz (non ITU-T)
2 = 2100 Hz Selects the CED frequency 2100/1080 Hz
025 COMM. Start-Up 1 = First
2 = Second Selects the communication start-up condition (XMT
and Polling).
(Used when Echo Suppression is disabled.)
Function Parameter Table
No. Parameter Selections Function