Panasonic Workio DP-1520P, Service Manual

Page: 3 / 496

3
Important Notice
Please read this notice completely
BEFORE
installing any optional
accessories. As failure to properly install the additional board or
connector with the power ON could damage the machine’s SPC or
SC board.
Please follow the instructions below:
1. It is essential that you turn OFF the Main Power Switch located
on the Right Side of the machine.
2. It is essential that you unplug the AC Power Cord from the wall
outlet. (During a Lightning Storm, to prevent electrocution
disconnect the Telephone Line Cable first before unplugging the
AC Power Cord, if the Fax option is installed.)
3. Please read the installation instructions carefully and follow each
step.
<Example: DP-1820E>
Note:
O = Power OFF, l = Power ON
Note:
If the Hard Disk Drive Unit is installed, to prevent a Scan Disk Function from being
performed (similar to Windows OS when the power is abruptly interrupted), it is
important to follow the step sequence below when turning OFF the Power Switch on the
machine.
1. If the machine is in the "
ENERGY SAVER (Shutdown Mode)
", you may turn the Power Switch on the
Right Side of the machine to the OFF position. If it is not in the "
ENERGY SAVER (Shutdown Mode)
",
continue to step 2 below.
2. Press "
FUNCTION
" and "
ENERGY SAVER
" keys simultaneously first.
3. Wait approximately 10 seconds while the machine writes the closing status onto the Hard Disk Drive
Unit and advances into "
ENERGY SAVER MODE
".
4. Turn the Power Switch on the Right Side of the machine to the OFF position.
5. Unplug the AC Power Cord. (During a Lightning Storm, to prevent electrocution disconnect the
Telephone Line Cable first before unplugging the AC Power Cord, if the Fax option is installed.)
* The specifications are subject to change without notice. Panasonic Communications Co., Ltd. reserves
the right to make improvements in the product design without reservation and without notice.