Panasonic WJ-HD716K, Installation Manual

Page: 22 / 156

22
Note:
• After attaching the front cover to the recorder, be sure to
turn on the power of front cover.
■
Rear view
EXT STORAGE
MODE DATA RS485(CAMERA) 10/100BASE-T
ALARM
ALARM/CONTROL
VIDEO
OUT-CASCADE-IN CASCADE IN
MONITOR
OUT
OUT MONITOR OUT(HD) AUDIO IN
AUDIO
OUT
3 2 1
1 2 3 4 5 6 7 8
1 2 3 4
4 2
3 1
1 2
5 6 7 8 9 10 11 12 13 14 15 16
IN
OUT
2
1
3 4 5 6 7
7
1 2 1 2
8 9 10 11 12 13 14 15 16
POWER
AC IN
SIGNAL
GND
ON
OFF
OUT
IN
OUT
CASCADE
1
2
q w e r t y u
!2 !3 !4 !5 !6 !7 !8 !1
i
!0
o
q
Alarm/Control connector (D-sub 25-pin) [ALARM/
CONTROL]
Connect a control switch to control the recorder using
an external device such as a buzzer or a lamp.
(
+
Page 44)
w
Alarm connector (D-sub 25-pin) [ALARM]
Connect an external device such as a sensor, door
switch, etc. to this connector. (
+
Page 48)
e
External storage connector 1-3 [EXT STORAGE]
Connect the optional extension unit (WJ-HDE400) to this
connector using the dedicated connection cable provid-
ed with the extension unit. (
+
Page 33)
r
Mode switch [MODE]
Determine the operational mode of the recorder using
this switch. (
+
Page 51)
t
DATA port [DATA]
Connect a PS·Data compatible device to this port.
(
+
Page 35)
y
RS485 port [RS485/CAMERA]
Connect an RS485 combination camera to this port.
(
+
Page 42)
u
Network port [10/100BASE-T]
Connect this recorder to a network (10BASE-T/
100BASE-TX) using this port. When the recorder is con-
nected to a network, it is possible to operate the record-
er from a PC via a network.
i
Audio cascade input/output connector (RCA pin
jack) [CASCADE IN, OUT])
Use this connector for audio output from another record-
er when it is connected in cascading connection.
o
SIGNAL GND terminal
Connect this terminal to the SIGNAL GND terminals of
the devices in the system for signal ground. When oper-
ating the recorder and the devices in the system without
signal ground, oscillation or noise may be produced.
!0
Power button [POWER]
Press this button to turn on/off the power of the record-
er. When this button is pressed again, the operation is
finished and the power is turned off.
!1
Power inlet [AC IN]
Connect the provided power cord to this inlet. The
power plug is a 2-conductor plug with grounding termi-
nal type.
!2
Video input connector 1 to 16 (BNC)
[VIDEO IN 1 to 16]
Connect system cameras and combination cameras to
these connectors. When connecting combination cam-
eras, connect them to the video input connector 1-8
(coaxial communication compatible).
!3
Video output connector 1 to 16 (BNC, active loop
through) [VIDEO OUT 1 to 16]
Images input to the video out connectors 1-16 will be
output from these connectors. When the power is off,
images will not be output to the video output connector
1-16.