Panasonic VL-MV26, Installation Manual

Page: 76 / 122

5-10. Main monitor programming
Setup Tool
5
The VL-MW251 programming
1. Press and hold [ OFF ] , [ TALK ] , and [ MENU ] at the same time (3 buttons total).
Continue to hold the buttons and perform the next step.
2. Press and hold the [ RESET ] button for about 3 seconds, then release the [ RESET ] button only.
The main monitor starts up and enters programming mode.
3. When the display lights up, release all the buttons.
4. Press the [
▲
] or [
▼
] soft keys to select
“APARTMENT MODE” → [ OK ]
.
The main monitor initialises its settings.
While performing the next steps, you can cancel without saving your settings by pressing M
OFF N.
5. Enter the room number.
a. Press [ + ] or [ - ] to select the desired number.
b. Press [NEXT >] to accept the entered number and advance the cursor.
c. Press [ OK ] when finished.
6. Enter the floor number.
a. Press [ + ] or [ - ] to select the desired number.
b. Press [ OK ] when finished.
7. Set lift permissions for visitors.
a. Press [ YES ] or [ NO ] to allow or prohibit lift usage for visitors to each lobby.
b. Press [
▼
] to select the next lobby station.
c. Press [ OK ] when finished.
8. Confirm the displayed settings.
Press [ EDIT ] to go back and enter the desired settings again.
9. Press [ SET ] to check for a duplicate room number.
If a duplicate room number is found, press [ YES ] or [ NO ] to select whether you want to overwrite the
existing room number settings.
If no duplicate is found, the settings are saved in the control box.
Note:
If you press [ SAVE ] , the settings will be saved in the main monitor only, and the main monitor will restart.
To save the settings in the control box, press [ SET ] .
Main monitor programing parameters
You can also use PC programming to configure these settings for each main monitor. Parameter names are slightly different when using PC programming.
Parameter Description Default
ROOM NUMBER Tells the system what room the main monitor is installed in.
(1
– 99999) -
FLOOR NUMBER Tells the system what floor the main monitor is installed on.
(0
– 99; 0 is the ground floor)
-
LIFT 1
LIFT 2
LIFT 3 Determines which lifts can be used by visitors to each
lobby station.
(Yes, No) No
(No lifts can
be used)
72