52
QR34662
Recording Movie
Insert a recordable DVD-RAM or DVD-R disc into this DVD Palmcorder.
1
Turn the DVD Palmcorder on.
Set the power switch to “
VIDEO” to turn the
DVD Palmcorder on.
After the ACCESS/PC indicator goes out,
perform the subsequent operation:
2
Check the subject on the screen (viewfinder or
LCD).
If using the viewfinder, pull it out.
3
Press the REC button.
The “
?
” mark in the viewfinder or on the LCD
screen will change to the “
/
” mark, and
recording will start.
During recording, the recording indicator on the
front of DVD Palmcorder will light.
Pressing REC again during recording will set the
DVD Palmcorder to the recording pause status.
4
When recording is finished, turn the DVD
Palmcorder off.
Note
:
•
See page 148 when recording movie is not possible.
•
See page 148 if it takes some time before recording is
possible.
•
See page 64 for on-screen information display.
•
It is recommended that you use DVD-RAM disc from
which recorded contents can be deleted.
•
Sound is recorded from the stereo microphone on the
front of DVD Palmcorder: Take care that this microphone
is not blocked.
•
You can press the REC button immediately after the DVD
Palmcorder enters the recording pause status, but no
further recording can be made while “DISC ACCESS” is
being displayed.
•
Recording will restart after the message disappears.
•
Take care that power is not interrupted while the
ACCESS/PC indicator is blinking.
•
The minimum recordable time of movie is approximately
3 seconds.
•
See page 95 for setting of Record LED (recording
indicator) On/Off.
•
For various functions available during recording, see
“Setting Up Camera Functions” on page 82.
•
Panasonic cannot be responsible for video and audio that
cannot be recorded or edited because of any defect.
•
The power switch can be changed over even during
recording, but the operation will not be changed.
•
Each time the DVD Palmcorder enters the recording
pause status, the counter display will be reset to
“0:00:00”.
•
When using DVD-R disc, do not perform the following, or
data on the disc may not be read:
- Using another device, doing additional recording on
DVD-R disc recorded on this DVD Palmcorder
- Using this DVD Palmcorder, doing additional recording
on DVD-R disc recorded on another device
Power switch
Pressing REC
once will start
recording;
pressing it
once again will
temporarily
stop recording.
ACCESS/PC
indicator
VDR-M30PP_GB.book Page 52 Friday, March 14, 2003 8:53 PM
