45
QR34642
Removing Disc
1
Set the power switch to
“POWER OFF” to turn the
DVD Palmcorder off.
2
Press down the DISC
EJECT button once and
release it.
In a moment, the cover of
disc insertion block will
open slightly.
3
Gently open the cover until
it stops.
When the cover is fully
open, the disc will slightly
come out from the disc
guide, and stop.
4
Remove the
disc.
Hold the top
of Round
DVD
Holder as
shown in the
illustration and gently pull it out.
Note
:
•
Be careful not to touch the disc exposed portion when
removing the disc.
5
Gently push the section
indicated “PUSH CLOSE”
on the cover of disc
insertion block (on side), to
close the cover.
Note
:
Note
:
•
It is recommended that you turn the DVD Palmcorder off
when inserting or removing disc, in order to prevent faulty
operation.
•
Even after the DVD Palmcorder is turned on, the disc can
be removed unless it is in recording status. Hold down the
DISC EJECT button for approximately 2 seconds, and
then release it to remove the disc. (The DISC EJECT
indicator on the LCD screen will blink.) It is recommended
that you turn the DVD Palmcorder off before inserting or
removing disc to prevent misoperation.
•
Do not detach the battery pack or AC adapter/charger
until the DVD Palmcorder is completely turned off.
•
Do not insert anything other than the 8 cm DVD-RAM or
DVD-R disc into the disc insertion block: Doing so could
cause malfunctions.
•
Set the power switch to “POWER OFF” to turn the DVD
Palmcorder off.
•
When inserting or removing the disc, be careful not to
touch the inside of DVD Palmcorder (especially, the lens
of laser pickup).
•
When inserting or removing the disc, connect a charged
battery pack or AC adapter/charger to the DVD
Palmcorder: The disc cover will not open unless the DVD
Palmcorder is powered.
DISC EJECT
Hold disc
around this
portion.
VDR-M30PP_GB.book Page 45 Friday, March 14, 2003 8:53 PM
