Panasonic UF-E1, Service Manual

Page: 91 / 271

UF-E1
87
4.7. Information Code Table
Information Code
Code Mode Phase Description of Problem Cause
001 RCV
COPY
C
D Leadingedge of the recording paper fails
to reach the Registration Sensor. Recording paper jam.
Registration Sensor abnormal.
002 RCV
COPY
C
D Recording paper has not completely
passed the Registration Sensor. Recording paper jam.
010 RCV
COPY
B
C No recording paper. No recording paper or paper is not set
properly. Recording Paper Sensor is
defective or it is not mounted properly.
012 RCV C
D The length of the received document is
over 380mm.
(Used in France only)
014 RCV
COPY
- Print Cartridge is not installed.
015 RCV
COPY
- Out of ink. Print Cartridge is defective or Out-of-ink.
Cradle contacts are damaged or dirty.
IM Detection Sensor defective.
SC PCB defective.
016 RCV
COPY
- Carriage does not move. Recording paper jam.
Obstruction in the Carriage path.
Encoder Strip dirty or damaged.
017 RCV
COPY
- Ink Cartridge is dried up. Clean the Ink Cartridge.
018 RCV
COPY
- Pressure plate is not positioned prop-
erly. Replace the Pressure plate position
micro switch.
030 XMT B RP Sensor does not go ON within 10
seconds after the document starts feed-
ing. Document is not set properly.
Defective RP Sensor.
031 XMT
COPY
C Transmitting document was longer than
1,050mm (or 41.3 in) The document may be jammed.
Defective Registration Sensor.
032 XMT
COPY
C Transmitting document was shorter than
70mm (2.8 in) Document may get jammed.
Defective RP Sensor.
060 - A Cover open. Cover is not firmly closed.
Connectors are not firmly connected.
310 RCV
COPY
- Error for GPB guard time over. (Printer)
Communication error with GPB. GPB ROM defective
GPB RAM defective
GPB ASIC defective
400 XMT B T1 timer (35 5 sec) elapsed without
detecting 300 bps signal. Wrong number is dialed and the START
button is pushed.
Telephone line is disconnected while
dialing.
SC PCB (Modem) or NCU PCB is
defective. Receiver is defective. (It may
only be transmittingCED)
401 XMT B DCN was returned from receiver while
transmitter is waiting for CFR or FTT. No mailbox available in the receiver
Possible incompatibility. (Password
Transmission)
402 XMT B DCN was returned from receiver while
transmitter is waiting for NSF/DIS. Receiver might work in non-ITU-T mode
only.(Possibleincompatibility)
403 RCV
(Polling)
B Transmitter had no polling function. POLLED=ON (polling XMT ready) is not
set at the transmitter.
Document to be transmitted is not
placed at thetransmitter.