Panasonic UF-E1, Service Manual

Page: 105 / 271

UF-E1
101
5 Test Modes
5.1. Test Mode Table
The following test modes are provided to assist you in setting operational functions of the unit and determin-
ing the condition of the unit.
No. Test Mode Description
0 Test Pattern Printout Prints out a test pattern to check the printer mecha-
nism. This TEST MODE must be performed when SC
PCB is replaced or F-ROM data is initialized.
1 Function Parameter Setting Changes the function parameters. (the home position,
etc.)
2 System RAM Edit Factory use only.
3 Function Parameter List Printout Function Parameter list in Test Mode 1 and RAM data
in Test Mode 2 will be printed.
4 CIS Test Document scanning mechanism and electrical circuit
will be tested by scanning a document and checking
the output signal from the CIS.
5 Tonal Signal Generation & Binary Signal
Generation Generates various tonal & binary signals, by the
modem.
6 RAM Initialization Initialize RAM and restore the default value of the func-
tion parameters.
7 DTMF Signal Generation Generates various DTMF signals for dialing.
8 Not used
9 Flash Memory Test (Doc. MEM Test) Checks the Document Memory Flash Rom.
10 LED, LCD Test Checks the LED, LCD.
11 ID No.Setting ID number can be entered by this mode. This mode is
only for the countries where service personnel is to
enter the ID number.
12 Bi-direction Alignment Test Pattern Print-
out Print out a test pattern to calibrate for optimum bi-direc-
tional print alignment.
15 CIS Training This test mode must be done after CIS or SC PC Board
was replaced and after Test Mode 9 (Memory Test).
16-18 Not Used
19 Received Files Deletion Deletes all the files received in the memory.
21 Check Sum Calculation Calculates the check sum of the program ROM.
22-24 Not Used
25 Pen Voltage Adjust printer pen voltage.
26 PPP Log Print Print PPP protocol log.
27-30 Not Used
31 Data Modem Signal Transmission Transmits various signals by the data modem.