Panasonic UF-E1, Service Manual

Page: 165 / 271

UF-E1
161
c. ACCM
ACCM is a map for transmitting control codes transmissively (as data) on asynchronous links. As
shown in Figure 6.5.2.4, ACCM is a bit table with which each of 32-character control codes is identi-
fied and it is composed of 32 bits. For example, when the ACCM value is 001000h (bit 17 is ON),
the corresponding control code (DC1) is the subject of escape. Also, among those codes that are
set other than by ACCM, including escape code itself (7Dh) and flags (7Eh) must be escaped when
used as data.
In ACCM, there are receiving ACCM (32 bits) and transmitting ACCM (maximum of 256 bits in both
direction). In asynchronous mode, the default values for transmitting and receiving ACCM are
FFFFFFFFh (Escape all control codes). In other synchronous modes, these value swill be 0 (Noth-
ing is escaped.) The Appendix 2 of ISO3309-1991 (1/15/1992) stipulates HDLC under asynchro-
nous environment. In order to be compatible with this, DEL code (yFh) and the code with entry in the
highest bit of the control code designated in ACCM can be escaped.
In the ACCM setting, this can also be done as the LCP setting option. Figure 6.5.2.5 shows its struc-
ture.
Figure 6.5.2.4 Correspondence between ACCM and Control Code Table
Figure 6.5.2.5 Structure of LCP-ACCM setting option
Key Point
Indicates that control code with bit position from lower bit of 32 bit is sued
1
(Bit Position)
17 (11th) ON
DC1 is used as the control code
(Lower) (Higher)
1Fh
(Higher)
11h
(Byte position: Hexadecimal)
DC1
00h
(Lower)
NULL
3 2 1 0
ACCM Bit Map
(Value = 00010000h)
32 bit
Control Code
32 byte
1 0 9 8 7 6 5 4 3 2 1 0 9 8 7 6 5 4 3 2 1 0 9 8 7 6 5 4 3 2 1 0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
ACCM : Async Control Character Map.
Key Point
Composed of type, length, and ACCM bit map
1 2
Set as LCP setting optoin
Type (Value=2)
1 byte
Length (Value = 6)
1 byte
ACCM bit map
4 bytes (note)
Note: Transmitted from the upper byte.