Panasonic UB-5338C, Service Manual

Page: 20 / 136

20
3.3.5. Installing Panaboard to the optional Stand
Note:
1. Use the washers included with the electronic board. Do
not use the washers included with Stand.
2. Do not tighten the screws too much. This may deform the
Stand.
3. By tightening the two screws with washers through holes
A and B, the unit will be positioned 100 mm (3 15/16")
higher than normal height (1,930 mm [6' 4"]).
1. Attach the optional Stand to the unit.
• Each Stand has 3 holes (A, B, C).
1) Attach the Stand to the unit with the locking caster up.
2) When attaching the unit to the Stand at normal height (1,830
mm [6' 2/32"]), tighten the 2 screws (included in the Stand) with
washers using the hexagonal wrench through holes A and C.
2. Stand the unit up.
3. Attach the rivets (included in the Stand) to the holes in the Stand
that are not already in use.
• Normal height: 2 places
• Higher than normal height: 4 places
4. Attach the clamp for the Power Cord to the upper side of the
Stand on the control box side.