Page 5-17
SETTING PRODUCTION
MA
TERIALS
5
5
. By pressing
UNLOCK
+
Squeegee open (Squeegee exchange)
, open the squeegee head.
6
. Adjust the width of the solder-leakage
preventing blocks.
∗
The space between the blocks should be a little
wider than the board width. (See the following
figure for reference.)
∗
F and R block widths should be about the
same.
∗
To use the solder auto-dispensing feature,
enable ‘AutoSolderSupply’ of the software
switch.(
And, slide the syringe holder to adjust the
nozzle in the vicinity of the center.
∗
The dispensing position can be adjusted a little,
to the position with large amount of solder to
be transferred to board.
NOTICE
Conventional squeegees and advanced squeegees are different in the remaining-
solder-on-mask detection sensor positions. (The mounting holes for the sensor
bracket need to be changed.)
∗∗∗∗∗
Be sure to locate the sensors at the correct positions.
Procedures for Using Advanced Squeegees (Option)
1E4C-E-OMA05-A01-00
1D3C-056P
1D3C-030E
1D3C-029E
1D3C-043E
1D3C-JEn-MaSo-001
1D3C-057P
Center between F and R squeegee
Solder rolling area of F-side squeegee
•
Conventional squeegees
•
Advanced squeegees
Summary of Contents for SP28P
Page 2: ......
Page 6: ...4 1E4C E OMA00 B01 00 MEMO...
Page 14: ...12 1E4C E OMA00 A02 01 MEMO...
Page 64: ...Page 1 12 MEMO 1E4C E OMA01 A02 01...
