Indicator status
Status
Off
The power plug is not connected to the outlet.
Red
Lit
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [ECO].
Blinking*
1
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [NETWORK].
Blinking*
2
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [NORMAL].
Green
Lit
Projecting.
Blinking*
3
The luminous lamp is turned off. The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [POWER
MANAGEMENT] is set to [READY].
Blinking*
4
The projector is preparing to project. The projector will project image after a while.
Orange
Lit
The projector is preparing to be switched off.
The power is switched off after a while. (Changes to the standby mode.)
*1 The indicator flashes in the cycle: 2.75 seconds (light) → 0.25 seconds (off) → 0.75 seconds (light) → 0.25 seconds (off)
*2 The indicator flashes in the cycle: 2.75 seconds (light) → 0.25 seconds (off)
*3 The indicator flashes in the cycle: 2.0 seconds (light) → 2.0 seconds (off)
*4 The indicator flashes in the cycle: 0.5 seconds (light) → 0.5 seconds (off)
Note
f
While the power indicator <ON (G)/STANDBY (R)> lights in orange, the fan is running to cool the projector.
f
For about 90 seconds after the projector is switched off, the luminous lamp does not light up even if the power is switched on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights/blinks in red.
f
The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lights/blinks in red). Refer to “Power
consumption” (
x
page 127) for the power consumption.
Powering on the projector
Before switching on the projector, make sure the projector and the external devices are correctly connected
(
x
page 31) and the lens cap is removed beforehand.
AUTO SETUP
3)
3)
2)
1)
1) Connect the power cord to the projector body.
2) Connect the power plug to an outlet.
f
The power indicator <ON(G)/STANDBY(R)> lights or blinks, and the projector will enter the standby mode.
3) Press the power <
v
/
b
> button.
f
The power indicator <ON(G)/STANDBY(R)> lights in green and the image is soon projected on the screen.
Attention
f
Be sure to remove the lens cap before starting projection.
Note
f
If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], it may take approx. 10 seconds longer
before the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.
36 -
ENGLISH
Chapter 3 Basic Operations - Powering on/off