70 - ENGLISH
4) Press
w
or the <ENTER> button.
f
The
[Signal Power On]
screen is displayed.
5) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[Off]
The [Signal Power On] function is disabled.
[On]
The projector automatically powers on when a signal is detected, without pressing the power
<
v
/
b
> button on the projector control panel or on the remote control.
Note
f
Only supports HDMI 1 IN, HDMI 2 IN, COMPUTER 1 IN and COMPUTER 2 IN inputs.
f
Depending on the computer model, the function may not be performed when the input is COMPUTER 1 IN or COMPUTER 2 IN.
[Auto Power Off (min)]
You can set the countdown timer interval. The countdown timer will start when there is no signal being sent to the
projector. The projector will automatically power off when the countdown has finished.
1) Press
as
to select [Eco Management].
2) Press
w
or the <ENTER> button.
3) Press
as
to select [Auto Power Off (min)].
4) Press
w
or the <ENTER> button.
f
The
[Auto Power Off (min)]
screen is displayed.
5) Press
qw
to set the timer.
f
The time can be set in 5-minute increments from 0 to 180 minutes.
f
The factory default value is 20 minutes.
[Standby Mode]
Set the power consumption during standby.
1) Press
as
to select [Eco Management].
2) Press
w
or the <ENTER> button.
3) Press
as
to select [Standby Mode].
4) Press
w
or the <ENTER> button.
f
The
[Standby Mode]
screen is displayed.
5) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[Eco.]
Select this item to reduce power consumption during standby.
[Normal]
Select this item to use the network functions, the serial communication function, or the functions
set in [Normal Standby] during standby.
Note
f
When [Standby Mode] is set to [Eco.], the network function cannot be used during standby. Also, some RS-232C commands cannot be
used.
[Normal Standby]
Perform the normal standby setting.
1) Press
as
to select [Eco Management].
2) Press
w
or the <ENTER> button.
3) Press
as
to select [Normal Standby].
4) Press
w
or the <ENTER> button.
Chapter 4 Settings - [Setup] menu
