46 - ENGLISH
Adjusting adjustable feet
Install the projector on a flat surface so that the front of the projector is parallel to the screen surface and the
projected image is rectangular.
If the screen is tilted downward, extend the front adjustable feet so that the projected image becomes rectangular.
The adjustable feet can also be used to adjust the projector to be level when it is tilted in the horizontal direction.
Adjustable feet can be extended by turning them as shown in the figure. Turning them in the opposite direction will
return them to the original position.
Maximum adjustable range
Adjustable feet : 18 mm (23/32") each
Attention
f
Be careful not to block the intake/exhaust vents with your hands or any objects when adjusting the adjustable feet while the light source is
on. (
x
page 25)
f
Adjust from the [Picture] menu → [Keystone] (
x
page 65) when the projected image is distorted.
About lens shift adjustment range
The projector supports lens shift in vertical direction. The following figure shows the lens shift adjustable range in
vertical direction with reference to the standard projection position.
Standard projection position
Projection screen width H
Projection screen height V
0.1 V
Note
f
The standard projection position indicates the projection screen position in the state without vertical shift adjustment.
Chapter 3 Basic Operations - Projecting
