E
NGLISH
-83
Gateway
A gateway is a relay point that provides a connection of two networks. It does not
operate in the ad hoc mode. It is necessary to assign the gateway address if the
projector is connected to the network of different segment or to the Internet in the
infrastructure mode.
For details of assigning the address, please consult your network administrator.
Host name
Set the name of the projector on the network.
The name must be up to 16 alphanumeric characters and symbols.
Use and buttons to change the value, and use and buttons to switch
the characters to be changed.
Press the ENTER button when the setting is completed.
Mode
Choose either "AD HOC" mode or "INFRASTRUCTURE" mode.
Set the projector to the "AD HOC" mode when it is used as described in "To use
wireless communication for the first time" and "If wireless communication has
already been established between PCs (in AD HOC mode)". Set the projector to
the INFRASTRUCTURE mode when it is used as described in "If wireless
communication has already been established using an access point".
Press the ENTER button when the setting is completed.
SSID (only in the INFRASTRUCTURE mode)
Change the projector's "SSID" to the one that is set for the access point with which
the projector communicates in the INFRASTRUCTURE mode.
• For the SSID of the projector, up to 32 alphanumeric characters and symbols are
available. For this reason, if the SSID of the access point cannot be used in the
projector, consult the network administrator and have the SSID changed to the
one that can be used in the projector.
Use and buttons to change the value, and use the and buttons to
switch the characters to be changed.
Press the ENTER button when the setting is completed.
Channel
Select the channel for use. It is necessary to select the same channel as used by
the wireless card of the PC with which the projector communicates.
In the INFRASTRUCTURE mode, the projector usually operates regardless of the
channel setting. However, communication may not be established depending on
the access point used unless the projector has the same channel setting as the
access point.
Use and buttons to select the desired channel and press the ENTER button.
Note:
• Available channels vary by the country (refer to page
67
).
