Start-up display
ENGLISH - 23
Preparation
▶
■
Initial setting (installation setting 2)
Set [COOLING CONDITION] depending on the
projection method. Refer to “Projection method”
(
page 30) for details.
After completed the initial setting, you can change
the setting from the [PROJECTOR SETUP] menu →
[COOLING CONDITION].
1) Press
◀▶
to switch the setting.
If the clasps are attached to the lamp case, please
remove them. For details, please refer to the enclosed
leaflet [Notice to User when Installing Projector]. If used
in a wrong setting or if the clasps are attached, it may
reduce the lamp and projector life.
INITIAL SETTING
SET
CHANGE
MENU SELECT
COOLING CONDITION
AUTO
ENTER
2) Press the <ENTER> button to proceed
to the initial setting.
▶
■
Initial setting (screen setting)
(Only for PT-DZ21KU, PT-DS20KU)
Set the screen format (aspect ratio) and display
position of the image. After completed the initial setting,
you can change the settings of each item from the
[DISPLAY OPTION] menu → [SCREEN SETTING].
1) Press
▲▼
to select an item.
2) Press
◀▶
to switch the setting.
16:10
SCREEN POSITION
Set as necessary for the screen in use.
INITIAL SETTING
SET
CHANGE
MENU SELECT
SCREEN FORMAT
ENTER
3) Press the <ENTER> button.
▶
z
Confirm the setting value and complete the
initial setting.
Note
z
If you press the <MENU> button while the [INITIAL
SETTING] screen is displayed, you can go back to
the previous screen.
z
To continue operations after completed the
initial settings, refer to “Select the input signal”
(
page 54).
