Panasonic PT-DS100XE ( ), Operating Instructions Manual

Page: 76 / 130

PROJECTOR SETUP menu
76
- ENGLISH
Settings
PROJECTOR SETUP menu
See “Navigating through the menu”
z
( Æ page 50).
See “MAIN MENU” and “SUB MENU”
z
( Æ page 51).
PROJECTOR ID
The projector has an ID number setting function that
helps the user to control two or more projectors either
simultaneously or separately with a single remote
control.
Press ▲▼ to select [PROJECTOR ID]. 1 )
Press ◄► to switch [PROJECTOR ID]. 2 )
The setting will change as follows each time
z
◄► is pressed.
ALL 1
64 2
Note
The ID number can be set to [ALL], or selected from [1]
z
to [64].
If the projectors are given ID numbers, their remote
z
controls must be assigned the same ID numbers,
respectively.
If the ID number of a projector is set to [ALL], it can be
z
controlled by the remote control or the PC with any ID
number.
If multiple projectors are used and some of them
have their IDs set to “ALL”, they cannot be controlled
separately from the projectors with other ID numbers.
For details on remote control ID setting, refer to “Setting
projector ID number to remote control” ( Æ page 21).
INSTALLATION
A projection scheme can be chosen depending on
the installation of the projector. If the picture is shown
upside down or in reverse, change the projection
scheme.
Select the setting by displaying the on-screen
z
indications using buttons of the remote control or
the control panel on the main unit.
Press ▲▼ to select [INSTALLATION]. 1 )
Press ◄► to switch [INSTALLATION]. 2 )
The setting will change as follows each time
z
◄► is pressed.
FRONT/FLOOR FRONT/CEILING
REAR/CEILING REAR/FLOOR
FRONT/
FLOOR
Setting on a desk/floor and
projecting from front
FRONT/
CEILING
Mounting on the ceiling and
projecting from front
REAR/
FLOOR
Setting on a desk/floor and
projecting from rear
REAR/
CEILING
Mounting on the ceiling and
projecting from rear
HIGH ALTITUDE MODE
If you use the projector at high elevation (1 400 m to
2 700 m), the [HIGH ALTITUDE MODE] setting needs
to be [ON] to set the fan speed high.
Press ▲▼ to select [HIGH ALTITUDE 1 )
MODE].
Press ◄► to switch [HIGH ALTITUDE
2 )
MODE] and press <ENTER> to select.
The setting will change as follows each time
z
◄► is pressed.
OFF ON
OFF
Select this when using in normal
environment (less than 1 400 m
above sea level)
ON
Select this when using at high
altitude (above 1 400 m and less
than 2 700 m above sea level)
When the confirmation message is 3 )
displayed, select [OK] or [CANCEL].
Note
The loudness of fan noise depends on the [HIGH
z
ALTITUDE MODE] setting.
The separately-sold Smoke Cut Filter cannot be used
z
when the [HIGH ALTITUDE MODE] is [ON].