Technical Information
ENGLISH -
121
Appendix
REMOTE 2 IN terminal
Using the [REMOTE 2 IN] terminal provided on the connection terminals of the main unit, it is possible to operate
the projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot
be received.
J
Pin assignments and control
D-Sub 9-pin (Outside view)
Pin No.
Signal name
Open (H)
Short (L)
GND
—
GND
POWER
OFF
ON
RGB1
Other
RGB1
RGB2
Other
RGB2
VIDEO
Other
VIDEO
S-VIDEO
Other
S-VIDEO
DVI
Other
DVI
SHUTTER
OFF
ON
RST/SET
Controlled by
remote control
Controlled by
external contact
Attention
Be sure to short-circuit Pins
z
and when controlling.
When pin
z
and pin
are short-circuited, the following buttons on the projector's control panel and on the remote control
cannot be used.
<POWER ON ( I )> button, <SHUTTER> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
When pin
z
and pin are short-circuited and then any one of pins to is short-circuited to pin , the following buttons
on the projector's control panel and on the remote control cannot be used.
<POWER> button, <INPUT SELECT> buttons (RGB1, RGB2, DVI-D, SDI, VIDEO, S-VIDEO), <SHUTTER> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
The above is explanation in the case where “REMOTE2 MODE” of “PROJECTOR SETUP”
z
“STANDARD”.
S-VIDEO
VIDEO
DVI-D
RGB2
Control panel located in a different room
LAMP
ON
RGB1
Standby
External control
Remote control/External control
Remote control
Projector set up in a meeting room
Summary of Contents for PT-DS100XE ( )
Page 130: ......
